WFI anchor flanges are designed to control internal pressure and temperature induced thrust in pipeline systems. WFI's advanced design provides cost reductions while maintaining required safety standards. Standard designs available in two series for either 40º or 90º temperature changes up to 1200 psig pressure (6"-36"). Special designs available upon request. Anchor flanges are commonly used as a means of restricting pipe movement and distributing axial thrust of the pipeline throughout the foundation in which the flange is anchored. Restraining the movement of pipeline sections is a design factor that must be considered particularly at points of directional change, connections to equipment at meter run locations, at river crossings, and for pipe runs at locations of discontinuity of restraint from the earth surrounding the line. The forces resulting from the restraining anchor are gradually absorbed by the fitting without imposing a concentration of stresses on the pipeline itself. Fillet welding of external collars, supports, lugs etc. is eliminated.

We could manufacture all kinds of forging products, including flange, shaft, ring and other pipe fitting. Diameter is from 1/2 inch to 160 inch. Height is 1 meters max. Standard: JIS, DIN, ANSI /ASTM, BS, NF. Steel Grade: SUS304 SUS304L SUS316 SUS316 SUS312. A105 LF2 S20C S25C 16Mn ASTM A694 F55 F60 F65. ANSI B16.5 FLANGE. Socket welding flange Lap joint flange 150LB 300LB 600LB. Thread flange Flat flange 150LB 300LB 600LB. Blind flange Welding net flange etc. 150LB 300LB 600LB. We could manufacture all kinds of shaft and other products according to your drawing. Forged steel Anchor Flanges are pressure retaining members that butt weld directly into the pipeline and provide an integral "flange" or collar which can transmit restraint from an anchor to the pipeline. Anchor Flange nominal pipe size and forging material grade.